2019年11月13日 星期三
2019年11月11日 星期一
Failed to launch Splunk with error "Validating databases (splunkd validatedb) failed with code '1'."
Recently I moved my previous Splunk db from my old laptop to the new one. There is an error "Validating databases (splunkd validatedb) failed with code '1’.”” When I tried to launch the Splunk. After did some googling, I found it was caused by file locked. The solution is to append the following configuration option to $SPLUNK_HOME/etc/splunk-launch.conf:
#########################
OPTIMISTIC_ABOUT_FILE_LOCKING = 1
訂閱:
文章 (Atom)
How to restore a deleted onenote page
復原不小心誤刪的onenote
-
Hard limit: 一般指不管任何狀況下,使用者都不被允許超出使用限制量 Soft limit: 則是允許使用者在一定時間範圍內,可以使用超過使用限制量,之後才會作處理(甚至根本不處理),在軟體功能上,常常會有所謂的paper license 或paper lim...
-
1.從網路上下載文鼎注音字形 201601111329270 2.開啟字體簿 F4 —>其他—>字體簿 3.安裝新的字體 4.開啟word,把要轉換的中文,選好後,選 AR stdKaiZuinn Md 即可
-
最近在使用外接螢幕時投影時,發現螢幕常常有閃爍的現象(flickering screen),上網查了一下,有人建議只要reset BMC後,一切就會正常了 可以上網查詢 reset BMC,或自己照下面的步驟執行即可 1.將電腦關機,同時移除外接螢幕 2.同時按住...